Test The Gsm Module Signal Strength; Gsm Connectivity Indication On A Carephone - TeleAlarm 970-170g Manuel D'installation

GSM Module
If the GSM Module is activated and a GSM media is entered, the
firmware version of the GSM Module is announced by the
Carephone when you enter the programming mode:
–
–
–
3.3

Test the GSM Module signal strength

NOTICE!
The signal strength test mode is available only if the GSM
Module is correctly inserted in the Carephone and initialized,
and that a destination number with GSM media is entered. Do
not move the Carephone afer the signal strength test.
–
–
–
The red lamp flashes for 3 minutes, the Carephone indicates
the signal strength by announcing a digit between 0 and 5:
–
–
3.4

GSM connectivity indication on a Carephone

The blue lamp on a Carephone equipped with a GSM Module
indicates the connectivity status in the following cases:
–
–
–

After a maximum supervision time of 60 seconds, if the
connectivitiy is not established, a "line failure" technical
message is generated by the Carephone.
TeleAlarm
The Carephone's version and build are announced.
The Carephone beeps.
The GSM Module firmware version is announced.
Enter test mode: press P and A together for at least 1 sec.
The Carephone announces "test".
Press 9, 2 and C.
0 means the signal is weak, 5 means the signal is strong.
If an error is coming back or if the GSM Module doesn't
answer, the message is simply replaced by a "beep".
Exit the test mode by pressing any button on the
Carephone. After 3 minutes, it automatically exits.
When programming a Carephone remotely or via keyboard
When the Carephone experiences a reset, initialization or
power supply interruption.
When updating rhe the GSM Module firmware
If there is no connectivity, the blue lamp flashes.
Installer Manual
Programming and testing | en
970-170g | V1.7 | 2015.09
43