Update And Check The Gsm Module Firmware - TeleAlarm 970-170g Manuel D'installation

42 en | Programming and testing
49 Phone number of GSM Module (without country code)
Program the own phone number for the GSM Module to be established for
the Carephone 62/61. Maximum length is 22 digits. If the country codes of
the phone numbers of the Alarm receving center and the GSM module are
the same, then it does not need to be part of the phone number. If the
country code is different, then it must be part of the phone number.
This function can also be performed with a keyboard shortcut:
– Press P, 4 and 9 together for at least two seconds.
– Type the phone number of the GSM Module with numeric keys.
– Press C to confirm.
3.2

Update and check the GSM Module firmware

NOTICE!
Before updating the GSM Module firmware, make sure that the
Carephone contains the last version of the Carephone
firmware. Refer to the user manual of the Carephone to check and
update the Carephone firmware.
You can update the GSM Module firmware on a Carephone with
the microSD memory card. Refer to the user manual of the
Carephone to see how to use a microSD memory card.
NOTICE!
Make sure that the Carephone is connected to the mains with
the power supply unit. Before reading from the microSD
memory card, make sure that it contains a file.
–
–
–
–
NOTICE!
After reading the GSM Module firmware to a Carephone,
perform a test call. Refer to the user manual of the Carephone.
970-170g | V1.7 | 2015.09
Press P, F and 5 together for at least 2 seconds.
The Carephone beeps.
The Carephone reads the GSM Module firmware from a file
on the microSD memory card.
The Carephone beeps again and returns to standby.
Installer Manual
GSM Module
TeleAlarm