Alignment Of The Sensing Face; Electrical Connection - IFM Electronic efector100 IM5142 Notice De Montage

Alignment of the sensing face

On delivery, the sensing face is facing the front (fig. 5). The sensing face can be
turned to the side (fig. 8) by loosening the fixing screw and turning the sensor
block (fig. 5-8).
5
7

Electrical connection

The unit must be connected by an electrician. The national and international
regulations for the installation of electrical equipment must be adhered to.
Disconnect power. Connect the unit as indicated on the type label.
The load resistance must not be higher or lower than specified in the data
sheet.
6
180°
8
90°
UK
3