Clatronic HTD 2939 Mode D'emploi page 25

WARNING:
• Children must not play with the appliance.
• Cleaning and user maintenance must not be carried out by
children, unless they are supervised.
• Do not try to repair the appliance on your own. Always contact an
authorized technician. To avoid the exposure to danger, always
have faulty cable be replaced only by the manufacturer, by our
customer service or by qualified person and with a cable of the
same type.
• The nozzles become hot during operation!
• If the appliance is used in the bathroom, disconnect it from the
mains after use as nearby water presents a hazard. This also
applies if the appliance is switched off.
• Please ensure that the inlet grille remains free of fluff and hairs.
Danger of fire!
• As additional protection we recommend the installation of a fault
current protection device (FI/RCD) with a rated current of not more
than 30 mA in the wiring system of the bathroom. Please contact an
authorised electrician for advice.
• This appliance is not intended to be immersed in water during
cleaning. Please observe the instructions that we have included for
you in the chapter "Maintenance and care".
Commissioning
• Unwind the mains cable completely.
• Attach a nozzle if necessary.
• You can dry single hair locks by concentrating the flow
of hot air with the hairdressing nozzle.
• The diffuser is the ideal solution to dry curly hair without
losing volume.
• In order to replace the attachment, first remove the old
attachment by pulling it off and then pushing on the new
one until it clicks into place.
Electrical Connection
• Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
• Connect the appliance to a properly installed earthed
socket.
Use
Slide the switch on the handle to the desired heat / blower
setting:
Position 0:
off
Position 1: gentle air flow and medium temperature
25