Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Explosion protected empty enclosure made of stainless steel type Ex-Cell
10
2
Legends
Warning
This symbol warns of a serious hazard. Failure to observe this
warning may result in death or the destruction of property.
Caution
This symbol warns of a possible failure. Failure to observe this
caution may result in the total failure of the device or the system or
plant to which it is connected.
Note
This symbol highlights important information
2.1 Safety instructions
Target group:
For skilled electricians and qualified personnel in accordance
with national legislation, including the relevant standards
and, where applicable, in acc. with IEC/EN 60079-14 on
electrical apparatus for explosive atmospheres and engineering/
development specialists according to IEC/EN 60079-0..
Empty component enclosures are not suitable for installation in
hazardous areas.
The enclosures are not suitable for use in equipment and systems
intended for Zone 0 and Zone 20 use.
The requirements of IEC/EN 60079-31 regarding excessive dust
deposits should be observed when the enclosures are used in
hazardous areas.
The enclosures should only be used when in a clean and undamaged
condition.
Once the complete equipment or protective system is assembled/
installed it should be tested and fully certified by a suitable testing
authority or authorised person.
The relevant national Health and Safety regulations as well as any
safety instructions given in these instructions or supplied additionally
by the Eaton / Cooper Crouse-Hinds GmbH, must be observed for the
safe use of this product.
3
Conformity with standards
The apparatus is conform to the standards specified in the EU-Declaration
of conformity, enclosed separately.
References to standards and directives in these operating instructions
always relate to the latest version. Other additions (e.g. details relating to
the year) shall be observed.
GB
Publicité
Table des Matières
