Publicité
Les langues disponibles
Les langues disponibles
These assembly instructions describe direct connection to a 12 V
on-board power supply or how to fit an alternative 12 V plug to the
following charging interface/connecting cable:
WM number
WM 22436
WM 10650
WM 28356
Prerequisites for an alternative 12 V plug
•
Suitable for a 13.8 V on-board power supply
•
The temperature range must correspond to the internal
temperatures arising during use
•
Current load > 6 A
•
Strain relief is essential
Remove existing 12 V plug
1. Cut connecting cable approx. 1 cm behind the 12 V plug.
2. Dispose of the plug you have cut off as electronic waste.
Connect the cable to a 12 V on-board power supply or
attach the alternative 12 V plug
1. Remove the insulation from the cable ends.
Charging interface/connecting
cable for
BASE-STATION 1 NG
BASE-STATION 3 NG
BASE-STATION II
BASE-STATION mini II
ACCUVAC Rescue
ACCUVAC Basic
MEDUMAT Transport
MEDUCORE Standard protective
carrying case
EN
5
Publicité
