Before Start Of Operation - Makita BHX2500 Instructions D'emploi

BEFORE START OF OPERATION

1. Inspection and Refill of Engine Oil
(1) Perform the following procedure, with the engine cooled down.
• Inspection： Please inspect whether it makes the machine horizontal, removes the oil cap, there is a oil to inside the range of the
upper limit lower limit mark of gauge. When it is insufficient, (especially, when it has not reached to the lower limit
level), please refill new oil.
• Refill：
Verticality (under the suction port cover) please do the machine, remove the oil cap. When oil is supplied from the oil
pipe port and oil level comes to the shelf inside the oil pipe, please stop oil supply.
(2) For reference, the oil refill time is about 10 h (refill frequency: 10 times).
(3) If the oil changes in color or mixes with dirt, replace it with new one. (For the interval and method of replacement, refer to P. 14)
Recommended oil: SAE 10W-30 oil of API Classification, Class SF or higher (4-stroke engine for automobile)
Oil volume:
Approx. 0.08 L
Inspection method of engine oil
• If the engine is not kept upright, oil may go into around the engine, and may be refilled excessively.
• If the oil is filled above the limit, the oil may be contaminated or may catch fire with white smoke.
Point 1 in Replacement of Oil "Oil Gauge"
•
Remove dust or dirt near the oil refill port, and detach the oil gauge.
•
Keep the detached oil gauge free of sand or dust. Otherwise, any sand or dust adhering to the oil gauge may cause irregular oil
circulation or wear on the engine parts, which will result in troubles.
•
As an example to keep the oil gauge clean, it is recommended to insert the oil gauge on its knob side into the engine cover.
Point 2 in Replacement of Oil: "If oil spills out"
•
It becomes cause of the oil soiling. Be sure to wipe out spilt oil before start of operation.
Upper limit
NOTE
Shelf
9
Lower limit
Upper limit
Lower limit
Shelf