Assembly Instructions; Assembly Of Blower Pipes; Assembly Of Vacuum Attachment - Makita BHX2500 Instructions D'emploi

ASSEMBLY INSTRUCTIONS

CAUTION : Before performing any work on the blower,
always stop the engine and pull the spark plug
connectors off the spark plug.
Always wear protective gloves!
CAUTION : Start the blower only after having assembled it
completely.

1. ASSEMBLY OF BLOWER PIPES

1) Align grooves in the blower pipe with pegs on the blower housing and
slide the pipe onto housing
2) Turn the blower pipe clockwise to lock it into place.
3) Place clamp around the opening of the blower pipe. Fasten
securely with bolt and nut
2.

ASSEMBLY OF VACUUM ATTACHMENT

1) Installing Vacuum pipe (nozzle)
!and open the protector
(1) Loosen the screw
WARNING!
When using this machine as a blower, be sure to confirm
that the screw
If the screw is loosened, retighten it.
It is dangerous to operate the machine with the screw
The operator's finger or clothing may be caught in the impeller,
which will result in a serious accident.
(2) Align the indicated on the vacuum pipe with the " "
indicated on the blower. Then insert the vacuum pipe into the
blower.
(3) Turn the vacuum pipe until the
indicated on the blower to lock the vacuum pipe.
(4) Fasten the vacuum pipe securely to the blower with screw
and bracket .
Caution: Do not perform the fastening operation in (4) above if the
blower is to be used in a country or region where the CE mark
is not applicable.
Caution: The screw do not tighten strongly too much.
WARNING!
Always hold the mounting end of the vacuum pipe when attaching /
detaching the vacuum pipe.
2) Installing Elbow and Dust Bag
(1) Open the fastener of the dust bag.
(2) Insert the elbow into the dust bag and take it out through the
bag's entry.
(3) Install the elbow on the blower
(4) Place clamp around the opening of the elbow. Fasten
securely with bolt
Caution: Do not perform the fastening operation in (4) above if the
blower is to be used in a country or region where the CE mark
is not applicable.
WARNING!
Do not attempt to pick up large wood chips, metals,
glass, stones, liquids, lighted cigarettes, fire works
.
or the like
Always mount the protector/vacuum pipe in the right way before
operation. Operation without the protector/vacuum pipe is dangerous,
the impeller may catch the operator's fingers or clothes and it can result
.
in serious injury
Do not attempt to remove the screw (1) or disassemble the vacuum pipe.
Regulation requires safety distance of at least 900mm between
the impeller and the top of the pipe
.
.
.
!is not loosened at each time of startup.
is aligned with the " "
.
and nut .
.
!loosened.
8
900mm