Xerox PHASER 3400 Guide D'installation page 7

Printing a Configuration Sheet
To see the IP address assigned to the printer, print the Configuration
Sheet:
1.
Make sure that the printer is on and connected to your network.
2.
Hold down the Print button (on the top of the printer) until all
four lights blink.
3.
Release the button.
Software Setup - Windows Environment
Make sure that your computer has TCP/IP for Windows and is set to
obtain an IP address automatically.
Note
If you administer a network where you assign a specific IP
address to each of the network computers and each of the
network devices, refer to the Phaser 3400 Personal Laser
Printer Network Guide (on the CD-ROM) for more
information.
Installing TCP/IP and Checking Settings -
Windows 9x and Me
1.
Click Start, select Settings, then click Control Panel.
2.
Double-click the Network icon.
3.
On the Configuration tab, look for TCP/IP in the list of network
components. If TCP/IP isn't listed, do the following:
a.
Click the Add button.
b.
Highlight Protocol and click the Add button.
c.
Highlight Microsoft on the left side, highlight TCP/IP on the
right side, and click the OK button.
d.
Follow the instructions on the screen. You may be prompted
for your operating system CD-ROM.
Quick Network Install Guide
3