Declaration Of Conformity - B+BTec Diamond 3 675 TS Traduction Des Instructions De Service D'origine

GB
Pump isn't running .
Cutting out of align-
ment .
12. C DECLARATION OF
CONFORMITY
We declare under our sole responsi-
bility that this product is in conform-
ity with the following standards or
standardization documents EN ISO
12100:2010, EN 55014-1:2006,
EN 55014-2/A1:2001, EN 61000-
3-2:2006, EN 61000-3-11:2000,
EN 12418.+A1:2009, conforms to the
provisions of the guidelines 2006/42/
EG, 2004/108./EEC, 2006/95/EG,
2000/14/EG, 2011/65/EU.
Subject to change without notice .
Zevenbergen, August 2020
R.G.W. van den Boogaart
General Manager
For spare parts or advice contact
B+BTec
Munterij 8, 4762 AH Zevenbergen
The Netherlands
+31 168. 331 260
info@bbtectools .com
DIAMOND3
The pump is not switched on .
The impeller or suction filter of
the pump is damaged .
No proper connection of the
power cable .
Machine is not leveled out.
Unstable working surface.
Improper or glazed diamond
blade .
675TS
®
Switch on the pump .
Replace damaged parts .
Have the connection checked .
Loosen the screws for the legs .
Pick up the machine a little bit on
one end . Let the machine down
again and tighten screws . Per-
form the same procedure on the
other end . The machine should
now be leveled out .
Make sure the machine is placed
on a leveled surface .
Replace or dress the diamond
blade .
18.