Technical Data; Disposal - weinor BiRec MVLED Instructions De Montage

Technical data

8
Power supply
Frequency
Maximum power input of motor
Maximum power input of light
IP code
Permissible ambient temperature
Radio frequency
Radio protocol
Supply line
Awning motor input
Motor input for Valance Plus
(BiRec MVLED only)
Light connection
Awning switching method
Light switching mode
Compatibility

Disposal

9
Do not dispose of used or defective electrical or electronic devices in household waste. They must
be returned to the manufacturer or taken to a local collection point.
BiConnect BiRec MVLED/MLED
Assembly and installation instructions/ Instructions de montage et d'installation
We reserve the right to make technical changes/ Sous reserve de modifications techniques
230 V
50 HZ
250 W
Certified for Becker R30/17C PS(+), R40/17C PS(+),
50/11C PS(+)
32 W;
at least. 1 – max. 11 LEDs, weinor system; max. 680 mA
IP 54
20 to +80°C
868.3 MHz
BiConnect/ Elero/ Griesser
AMP male connector, 2-pole with earthing cable and ring-
type terminal for 6 m cable with safety plug
AMP female connector, 4-pole
Blue – black – brown – green/yellow
AMP female connector, 4-pole
Blue – black – brown – green/yellow
Female push-on connector, 2.8 mm (red/black)
Awning runs on self-sustaining power until end position is
recognised;
coordinated operating mode with retraction protection
(BiRec MVL only)
Light on/off
Dimming of light
BiEasy hand transmitter (bidirectional only)
•
Remoto hand transmitter (unidirectional only)
•
BiEasy wall transmitter 1MW-3V
•
• BiSens Agido-3V product protection sensor
BiSens SWR 230 V sun/ wind/ rain sensor
•
BiSens SW 230 V sun/ wind sensor
•
• BiSens SW Solar sun/ wind sensor
• BiSens Sun Solar sun sensor
Version 4 2020-07-08
Item number/
Numéro d'article 116692-0000 Page 13/28