Candy CBT625/2X Manuel D'instructions page 9

If there is gap between the wall and the cooker hood, you may install the L-shaped
bracket on the bottom of the hood by two screws (3 x 12mm).
The installation of the L-shaped bracket is optional.
Note: The expansion pipe is not included in the product.
WARNING:
Start Using Your Cooker Hood
Rocker switch
1. Insert the power plug into the socket.
2. Push switch ① to , the lamp will be on; push switch ① to "0", the lamp will
be off.
3. Push the switch ② into "I、II", the motor will be on "low、high" two
speeds, push into "0", the motor will be off.
 For safety reason, please use only the same
size of fixing or mounting screw which are
recommended in this instruction manual.

Failure to install the screws or fixing device in
accordance with these instructions may result
in electrical hazards.
Rocker switch
8