10. Diagnostic And Faults - Sagem Axium HTD501 Manuel D'utilisation

10. Diagnostic and faults

Symptoms:
After initial set-up and after connecting your Flat
Screen DLP™, the on/off indicator light does
not light up.
The appliance does not switch on when the
on/standby button on the front panel or the
on/standby button on the remote control is
pressed.
There is no picture.
Black and white picture or picture interference.
No sound.
Sound weak or discordant during terrestrial
reception.
Frozen picture.
Your appliance does not start up when you exit
standby by pressing the front panel button and
the standby button on your remote control.
No picture on PIP mode.
The remote control is not working normally.
Recommended checks:
Check that the mains cable to Flat Screen DLP™ is
connected to the appliance and the wall socket. Also check
that the switch on the left of the appliance is pressed to
position I.
Check that the mains cable to Flat Screen DLP™ is
connected to the apparatus and the mains socket. Also check
that the switch on the left of the appliance is pressed to
position I.
The on/off switch is green and the Flat Screen DLP™ menus
are available: Check that your video appliances are connected
correctly and that you have selected the correct source for
your Flat Screen DLP™ (Chapter 8.5: Choice of sources).
Check that the aerial lead is correctly connected to the wall
socket of your Flat Screen DLP™. Also check that you have
the channels saved by your Flat Screen DLP™ in the Options
/search/edit list menu. If this is not the case, perform a manual
or automatic search.
Also check that the switch on the left side of the apparatus is
pressed to position I.
The internal temperature indicator light is flashing red: respect
the user precautions to avoid an excessive increase of the
internal temperature (chapter 1: precautions).
The lamp condition indicator light is red: the lamp has gone
past its standard working life and may no longer be
functioning. It must be changed.
Check that you have selected the correct video format: e.g.
RGB video source from a DVD player displayed in S-video on
your Flat Screen DLP™: check by pressing the picture source
selection button if the type of source selected is compatible
with the source emitted.
Check that the colour adjustment is not at minimum.
Check that the volume is not set at minimum and that mute
has not been activated.
Check that your appliances are correctly connected to your
Flat Screen DLP™.
Set sound to Mono.
Check that you have not held the picture: press the "PICTURE
of TELETEXT PAGE HELD" button.
The ON/STANDBY indicator light flashes orange for 20s then
turns to red or still flashes orange, switch off the appliance
using the switch to the left of your Flat Screen DLP™. Wait
30s and restart is using the normal procedure.
Check that you have selected sources that is active in PIP
mode (Chapter 8.8 Double picture mode selection).
Change the batteries.
22