Automatic Installation; Modifying The Programme List - Sagem Axium HTD501 Manuel D'utilisation

6.3.3.

Automatic installation

AUTO TUNING
SEARCHING
CHANNEL 52
CHANNELS FOUND : 2
MENU KEY TO STOP SEARCHING
6.3.4.

Modifying the programme list

IMAGE AUDIO
CODE GENERAL
PROTECTION COUNTRY
SOURCES MANUAL
PC DATA AUTO
SEARCH LIST EDITION
LIST EDITION
PROG. FREQ.
1 479,5
2 527,25
3 599,25
4 671,25
5 735,25
6 789,25
DELETE MOVE
NB: You can display the selected screen at any time
by pressing the OK button.
Press the MENU button to exit.
OPTIONS INSTAL.
NON CODE
PROTECTION VERROU
ATTENTION
SOURCES la configuration sera perdue CHAINE
CONTINUER
DONNEES PC MODIF. CODE
Touche BACK pour annuler
RECHERCHE CONFIG. USINE
NAME N.R.
TF1 NONE
F2 LOW
F3 MEDIUM
C+ HIGH
F5 NONE
M6 NONE
NAME N.R. VIEW
OK
Select "AUTO" and validate using OK button.
Your previous search will be erased and replaced by the
new one, confirm by pressing OK button.
All channels are searched and saved automatically.
If the broadcast signal is recognised by the transmission of
a teletext page, programmes will be named and classified.
You can decide to stop the search at any point in time, by
using the MENU button.
Your search results will not then be saved.
You can modify the programme list that is a result of your
search at any time.
Press the MENU button.
Select the "INSTALL." chapter using the OK button.
Select the "LIST EDITION" chapter using the OK button.
From this screen, you can:
• Delete a programme
Go to the line of the programme to be deleted and press
the red button to delete it. If you make a mistake, press
the red button again and the deleted programme will be
restored.
• Move a programme
Go to the line of the programme to be moved and press
the green button to select it (a "D" will appear to the left
to indicate the selection), move it using the W or V
keys, then validate the location using the green button.
• Change the programme name
Go to the line of the programme name to be modified
and press the yellow button to select it.
Enter the first characters. Move through the characters
using the W and V buttons.
Move forward one character using B then enter the
second etc. (Maximum 6 characters).
Validate using yellow button at end.
• Apply noise reduction filter to a programme
Go to the line of the programme name to be modified
and press the blue button to change the filter.
Each press on the blue button applies the next filter.
Apply a "weak", "medium" or "strong" filter according to
your reception.
Choose "none" if no filter is necessary.
10