Set Up; Aerial Connection; Mains Connection; Switch On - Sagem Axium HTD501 Manuel D'utilisation

2.

SET UP

2.1.

Aerial connection

Insert the end of the coaxial cable leading from your aerial into the aerial input socket at the back of
the Flat Screen DLP™.
Your Flat Screen DLP™ is fitted with 2 tuners, but only one cable is needed to supply both.
2.2.

Mains connection

Insert the mains plug into a 220-240 V socket that is earthed (3 pin).
2.3.

Switch on

Setting up the Flat Screen DLP™:
Press the stand-by button * on your remote control or press the standby button * on the front
panel of your appliance.
NB: The on/off indicator light located on the front panel of your Flat Screen DLP™ flashes orange
whilst the lamp is warming up then changes to green when your Flat Screen DLP™ is in use.
When you set up your Flat Screen DLP™ for the first time, you can take advantage of a rapid
installation procedure after this warm-up phase (see next chapter). Connecting other audio/video or
PC appliances is covered in chapter 7.1. Before looking at this, proceed to the rapid installation.
Switch the appliance on by pressing the switch on the left
of your appliance.
Setting up your remote control:
Open the battery compartment cover and insert the two R6-1.5V
type batteries.
Make sure that the batteries are installed correctly.
Do not use batteries of different types or rechargeable batteries.
4