Koala Kare KB200 Mode D'emploi page 2

KB200
Please Note: To assure proper installation, it is suggested that a qualified person or carpenter install
the Koala Baby Changing Station. Koala Kare Products will not be responsible if the station is not
installed properly. Koala Baby Changing Stations have been tested to hold a substantial static load. The
unit must be attached to a permanent wall that is capable of holding a substantial load. The maximum
recommended total weight for this baby changing station (including baby and parcel bag) is 60 lbs.
Excessive weight may cause a hazardous or unstable condition to exist.
Restraint System: To fasten the waist restraint strap, place strap around child's midsection, and
push spring tabs into buckle until both spring tabs lock in place with an audible "click". Straps can be
adjusted to make strap tighter or looser as required.
Inspection Criteria:
• A properly maintained baby changing station:
• Opens and closes smoothly
• Has both ends of a functioning, non-frayed strap:
buckle clicks when closed and strap is attached to unit at both ends.
• Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
• Provides a clean, convenient place for customers to attend to their children.
gloves
1/8" (3 mm)
(regular masonry)
&
drill bits
six ¼" x 3" Phillips
panhead wood screws
Operating Instructions
Tools Needed
drill pencil
Phillips head
screwdriver
Hardware Provided
four 8-32" x 5/16" flange
button Phillips head screws
measuring
stud finder
tape
7/32" (6 mm)
(regular masonry)
&
drill bits
level
½" (13 mm)
(regular masonry)
&
drill bits
four ¼" flat washers