Assembly - Husqvarna 340iBT Manuel D'utilisation

SAVE THESE
INSTRUCTIONS
Introduction
WARNING:
understand the safety chapter before you
assemble the product.
To assemble the tube and handle on
the product
1. Put the clamp (A) on the flexible tube (B) and push
the flexible tube onto the blower outlet (C).
A
C
2. Put the screw (D) on the clamp below the tube and
tighten the screw.
3. Attach the transport strap (E) to the guide track of
the joint swivel (F).
E
1166 - 007 - 30.06.2020

Assembly

Read and
B
D
F
4. Put the clamp (G) on the flexible tube (B) and
attach the joint swivel (F).
G
B
5. Put the screw (H) on the clamp below the tube and
tighten the screw.
6. Align the knobs (I) to each side of the joint swivel
(F).
K
I
F
7. Attach the operation handle (J) to the guide track
(K) of the joint swivel (F). Make sure that the screw
on the operation handle is on the bottom side of the
control pipe.
8. Tighten the screw on the operation handle fully.
F
H
J
9