Publicité
Les langues disponibles
Les langues disponibles
3.
Mounting and Settings
3.1 Range adjustments
1.
Remove
2.
Press locking clips
circuit board
3.
Make required adjustments to the input range, hysteresis, frequency
and relay control using the DIP switches.
4.
Replace connector after making adjustments
The connectors have been coded by the manufacturer, ensuring that
they cannot be reversed
5.
If using the feed-through version, push through enclosing wire
Warning!!
The circuit board can only be inserted in one position.
3.2 Cross-connections for voltage supply
A maximum feed through of 2 A is possible
The cross-connectors have been coded by the manufacturer, preventing a
short circuit should the cross-connectors be reversed
connector
on both sides of the enclosure and pull out the
.
13
Publicité
