Installing Rails - Leer PACE EDWARDS ULTRAGROOVE ELECTRIC Notice D'installation

HARDWARE
USED
HARDWARE
:
• Remove the protective paper from the foam on the underside of the Rail flanges.
USED:
This is for packaging purposes only.
• Next identify the left and right side rails (FIG 5A). The rail flange and foam towards
the outside of the truck bed.
HARDWARE
1/4 -20 X 5/8" Rail
Screw x2
HARDWARE
USED
:
1/4 -20 X 5/8" Rail
1/4" Lock
Washer x2
1/4 -20 X 5/8" Rail
Screw x2
• First, make sure that the Lead Rib Flange is in pulled toward the tailgate enough
1/4" Flat
Washer x2 to clear the Canister Flange
1/4" Lock
Washer x2
and Canister Stop (FIG 5B).
Figure 5B shows that
the lead rib needs to be
pulled out toward the
1/4" Flat
Washer x2
tail gate. Now hook the
rail into the rail guide
and roll it down making
sure to not get the
sweep seal folded
back into the rail
(FIG 5C).
Hook Rail
feature
into Rail
Guide here
STEP 5: INSTALLING RAILS
Tailgate End
USED
:
Tailgate End
Screw x2
Pull Out
1/4" Lock
Washer x2
Lead Rib
Flange
Canister
Pull Out
Flange
1/4" Flat
Washer x2
Canister
Stop
Lead Rib
FIG. 4B
Flange
FIG. 5B
Canister
Flange
Canister
Stop
FIG. 4B
FIG. 5B
Sweep Seal
Left Rail
Right Rail
Left Rail
Tailgate End
FIG. 5A
Right Rail
FIG. 5A
Pull Out
Lead Rib
Flange
Canister
Flange
Canister
Stop
FIG. 4B
FIG. 5B
Lead Rib Notch
FIG. 5C
Cab End
Left Rail
Right Rail
Cab End
FIG. 5A
Cab
7