Stadler Form Jack Mode D'emploi page 12

Setup / operation
1. Place Jack in the desired location on a flat surface. Please take care
not to place Jack on a surface sensitive to water and do not place any
moisture-sensitive appliances close to the humidifier. Plug Jack into a
suitable power socket.
2. Fill in the water tank (2) and place it on the humidifier. Important: Please
do not move Jack when it is filled with water. The water could splash out
of the interior tank and into the electronics.
3. Next, turn on Jack by pressing the on/off/night mode (8). You can now see
the current humidity on the display (4). If the display shows "no", it means
that there is no water in the humidifier.
4. By repeatedly pressing the output level button (9), you can choose your
desired output level from little to high.
5. If you push the button for the humidity level (10), you can choose the
relative humidity between 40% - 70%. The humidifier switches off auto-
matically as soon as the desired relative humidity is reached. If you wish
to run the humidifier continuously, please choose the function "co".
6. With the button for preheating (11) you can switch on the preheating. The
water is being heated up to 80°C which allows the humidifier to reach a
higher output. If you see the point in the lower right corner of the display
(4), the preheating is switched on.
7. As soon as you see the information „no" in the display (4), the water tank
is empty and needs to be refilled. Switch off the unit, take the water tank
(2) and refill it (see page 3).
Note: Should you see droplets (or other signs of dampness) on or around
the unit, this is condensed water from the humidifier. This means that the
air can no longer absorb the moisture from the humidifier. Please turn the
output down so that droplets are no longer visible.
Cleaning
Before you clean the appliance, always switch off and unplug the plug from
the socket.
Attention: Never submerge the unit in water (danger of short circuiting).
• To clean the outside, wipe with a damp cloth and then dry well.
• To clean the inside, remove the water tank (2) and the ionic silver cube (12).
Then you can clean the ultrasonic membrane with a normal household
decalcifier. It is important during this that the level of water inside the
unit does not go higher than 45 mm. Should the level of water accidentally
exceed 45 mm, contact Stadler Form or a specialist technician immediately.
Should not all residues be able to be removed, then you can clean the
ultrasonic membrane with the help of the cleaning brush (front or reverse
side). Please do not scrape the membrane with a hard object. With persis-
tent calcification, we recommend that you decalcify the unit several times
in a row. After decalcifying, rinse the lower part and then dry thoroughly.
• To clean the water tank, rinse it with warm water. Should calcification be
visible, you can also decalcify the water tank. Afterwards, rinse the water
tank and then dry it.