Cleaning - SilverCrest SHC 2000 A1 Mode D'emploi

■ If you wish to dry your hair especially gently, or create a so-called "air-dried
wave", then use the finger diffusor 7. Start by removing the styling jet 1
with a downwards snapping motion.
Fit the finger diffusor 7 by pushing it with light pressure onto the hair dryer
so that it snaps into place and sits evenly on the hair dryer.If you no longer
require the finger diffusor 7, wait until the appliance has cooled down and
pull it off with a downwards snapping motion:
■ Before you comb your hair out, allow it to cool so that the shaping and styling
can retain its form.
You can use the cooling level button 6
■

Cleaning

RISK OF ELECTRIC SHOCK
► Always remove the mains plug from the socket before you clean the appliance.
► Under no circumstances may you immerse the appliance in water or other
liquids when cleaning it!
► After being cleaned, the hair dryer must be completely dry before using it
again.
WARNING - RISK OF PHYSICAL INJURY!
► Allow the appliance to cool sufficiently before cleaning it.
CAUTION - PROPERTY DAMAGE!
► Do not use any aggressive cleaning liquids or solvents. They could damage
the surface.
■ 8 │ GB │ IE
to cool down your hair down.
SHC 2000 A1