Troubleshooting - Monster Power PowerCenter HDP2400 Manuel De L'utilisateur

Symptom
The PowerCenter is
not receiving power.
14

TROUBLESHOOTING

Possible Cause
The PowerCenter
is not turned On.
Too many devices are
connected, causing an
overload, tripping the
Thermal Circuit Breaker.
Remedy
• Turn the PowerCenter switch on.
• Make sure the PowerCenter's AC power plug
is plugged into a properly grounded
120 volts (nominal) wall outlet.
• In some households, a wall switch may need
to be turned on to make the wall outlet
active. Try turning on the light switches
located near the wall outlet.
• Press the PowerCenter Thermal Circuit
Breaker button in to reset. Please allow
10 minutes before attempting to reset.
If you reset too soon, the breaker will
prematurely sense power overload
and not allow the PowerCenter to operate.
• If the Circuit Breaker continues to trip,
try moving one or more components
to another PowerCenter. You may be drawing
too much current through one PowerCenter.