Memory/Preset Operation - Toshiba RAS-M10YDCV-E Manuel Du Propriétaire

MEMORY/PRESET OPERATION

Memorize the frequently used operation setting by the MEMO button for
convenience.
Start the air conditioner in the operation mode which you want the remote
controller to memorize.
Push the button as follows while the air conditioner is in operation.
1
MEMO button
Push this button briefly to standby memorizing the setting.
All the icons currently displayed except for the clock display and
mark flashes.
2
MEMO button
Push and hold the MEMO button for more than 3 seconds while the
display flashes.
The mark is indicated and the setting is memorized.
P
• If you do not push the MEMO button within 3 seconds or if you push
another button, the MEMORY setting is cancelled.
• Operation modes which can be memorized with the MEMO button are
MODE, Temperature, FAN, TIMER and High power.
To operate the air conditioner with the setting memorized by the MEMO
button.
1
PRESET button
Push the PRESET button. The setting memorized with the MEMO
button will be indicated and the air conditioner operates with regards
to the setting.
• The OPERATION lamp (green) on the switch panel of the indoor unit
goes on, and operation starts after approximately 3 minutes.
• Initial setting :
MODE : AUTO
Temperature : 22
P
13
AM
:
PM
P ON
OFF
˚ C
AM
:
PM
HiPOWER
AUT UTO
PRESET
START/STOP
FAN MODE AUTO
SWING ECO Hi-POWER
1
TIMER TIMER
FIX MEMO
2
ON OFF SET CLR
FILTER
RESET CLOCK CHECK
AM
:
PM
P ON
OFF
˚ C
AM
:
PM
HiPOWER
AUT UTO
PRESET
1
START/STOP
FAN MODE AUTO
SWING ECO Hi-POWER
TIMER TIMER
FIX MEMO
ON OFF SET CLR
FILTER
RESET CLOCK CHECK