Zanussi ZTE 273 Notice D'utilisation page 9

Door opening and
laundry loading
1. Open the door.
2. Load your laun-
dry (do not force
it in).
Caution! Do not
jam laundry in
between the loading
door and rubber seal.
3. Close loading
door securely.
Lock must audi-
bly lock.
1 2
Selecting additional functions
You can choose from the additional functions:
button 1 - Délicat (Delicate)
button 2 - Anti-Froissage (Long Anticrease)
button 3 - Alarme (Buzzer)
button 4 - Départ différé (Delay Start)
Délicat (Delicate)
Pressing this button allows drying to be per-
formed at a lower temperature, for delicate
items. The corresponding pilot light comes on.
This option can also be used for time controlled
drying.
Anti-Froissage (Long Anticrease)
A long anti-crease phase lengthen the anti-
crease phase (30 min.) at the end of the drying
additionally by 60 minutes. The drum rotates at
intervals during this phase. This keeps the laun-
dry loose and free of creases. Phase lasts in to-
tal 90 minutes. The laundry can be removed at
any time during the anti-crease phase.
When the option is active, the Anti-Froissage
(Long Anticrease) light is on.
www.zanussi.com
Selecting the pro-
gramme
Turn the programme
selector dial to the re-
quired programme.
The light Marche/Ar-
rêt (Start/Pause)
starts to flash.
4
3
Alarme (Buzzer)
When the drying cycle has finished, an intermit-
tent audible signal will sound. By depressing
button ALARM the acoustic signal is switched
off in the following cases:
• when selecting the programme
• when depressing the buttons
• when the programme selector dial is turned
to another position during the programme or
when you depress an option button during
the cycle
• at the end of the programme.
The corresponding light comes on.
Départ différé (Delay Start)
With the Départ différé (Delay Start)
button, you can delay the start of a
programme by 3, 6 or 9 hours.
1. Select the programme and additional func-
tions.
2. Press the Départ différé (Delay Start) but-
ton as many times as necessary (the lights
show which delay time have been chosen).
3. To activate the delay timer, press button
Marche/Arrêt (Start/Pause) . The lights 9h
6h 3h change on every three hours until
the time is getting on for start cycle.
Starting the programme
Press Marche/Arrêt (Start/Pause) button to start
the dryer after having selected the programme
and the options. The relevant light will stop
flashing. If the programme selector dial is turned
to another position, when the machine is run-
ning, the buzzer will sound and the programme
phase indicator lights will flash. The drum turns
alternately in both directions during drying.
All drying programmes end with a 10 minute
cooling phase. You may remove the laundry af-
ter this phase.
If the door of the appliance or the small door at
the bottom is opened while the programme is
running, this button must be pressed again after
closing the door in order to restart the pro-
gramme from the point at which it was interrup-
ted. This button must be depressed also after a
power failure and after having reinserted the
water reservoir, if it has been emptied in the
9