Side Mounting - Agilent Technologies TV 1001 SEM Notice De Mode D'emploi

Side Mounting

1
2
3
4
5
6
7
8
9
Figure 44
TV 1001 SEM User Manual / 87-900-973-01 (H)
Place the L-shaped bracket on the controller, with the pump cable toward
the bracket, and fix it by means of the three socket head screws M5, the
washers and the nuts. The 6 holes on the bracket allows to mount the
controller with the rotation angle that you like;
Turn the pump upside-down;
Place the bracket on the pump bottom (the hole on the bracket has the
same diameter as the pump bottom flange);
Screw a little bit the three screws M6 in the holes on the pump bottom;
Rotate the bracket until the controller is on the chosen position;
Tighten the screws properly;
Turn the pump again;
Plug the line card and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock signal to
start the pump.
Technical Information
TV 1001 SEM Controller Installation
17
283/296