3. Battery operation
Remove the cover from the battery compartments
the specified batteries – pay attention to correct polarity (+/-).
Safety instructions for batteries
• I nserting the batteries the wrong way round (incorrect +/-
polarity) can damage/destroy the appliance
• D o not store batteries within the reach of children. This applies in
particular to batteries that could be swallowed
• S eek immediate medical help for affected person in the event of a
battery being swallowed
• D o not attempt to revive batteries by heating up or similar mea-
sures. Primary batteries may not be recharged as this can result in
electrolyte leakage, fire and explosions
• D o not immerse batteries in water and do not store in a damp
place. Always store in a dry and cool place
• D o not throw batteries into fire. Do not attempt to open, solder
or weld
• D o not short-circuit batteries
Please dispose of batteries in compliance with legal requirements
(see section no. 9)
12
+
and insert
➀
➁
4. Coding
The transmitter and receiver must be assigned the same code
first before you can operate the receiver by remote control. 16
different coding possibilities are available to ensure that the receiver
reacts without fail to the transmitter's signals. Open the cover of the
battery compartment on the transmitter
a position between 1 and 16 chosen by you. The switch
receiver A has to be set the same position.
TIP: T est the required function before final installation at your chosen
installation point (see text no. 5).
5. Important instructions
• T he range between the transmitter and receive is max. 30 m in an
open area. The radio signal's strength depends on constructional
conditions when being transmitted through walls, panelling, furni-
ture and other obstacles – walls, in particular reinforced concrete
walls and ceilings – lead to a reduction in range.
• R eception can be severely impeded by screening from metal parts
so that a transmission of the signal is no longer possible. For this
reason, never attach the transmitter to a metal surface.
• T o install, drill appropriate holes at chosen installation point and
fasten the individual devices into place using the provided fasten-
ing materials. Test the function of the device at the chosen installa-
tion point first before completing final installation.
and turn the switch
to
➁
on the
13