therm-ic PowerPack Max Mode D'emploi page 13

charged status. The Powerpack must be turned off
(level 0) and disconnected from the heating sole
and charger for storage.
Avoid prolonged non-use. In case of long-term
storage, discharge and fully recharge the batteries
every 6 months! Proper storage of the battery
packs maximises the battery performance and
durability.
Clean the parts as needed with a soft, slightly
damp cloth and a mild cleanser.
Attention: Always remove the charger from the
outlet before cleaning it.
METHODS FOR ATTA CHI NG THE
P O WE R PA C KS
Fix the Powerpack to the outer edge of the shoe
with the wire clip (Fig. 1.1). However, for long-term
13
use, we recommend one of the attachment options
outlined below.
The Powerpacks can be attached as follows:
 use the Therm-ic Velcro Strap to fix them to the
shoe or lower leg (Fig. 1.2).
 use the Therm-ic Power strap adapter to fix them
directly onto the Velcro strap (picture 2).
 Use the Therm-ic ski boot adapter (Fig. 3) or the
Therm-ic Universal Powerpack Adapter to attach
them to the boot (Fig. 4)
 Place the Powerpacks into a jacket or trouser
pocket by using the Therm-ic extension cable
(available in 80 cm and 120 cm lengths), or
secure them to the hips (e.g. belt, etc.) (5).
More information is available at www.therm-ic.com
or from your specialist retailer.
WARNING:
Never fit the Powerpacks to smooth, slippery
surfaces where they could fall off and be lost.