Troubleshooting; Disposal Of The Appliance - SilverCrest SBT 3.6 D2 Mode D'emploi

Troubleshooting

Problem
The appliance is
not working.
The appliance
only runs slowly.
The epilation of
the hairs is very
painful.
Not all hairs are
plucked.

Disposal of the appliance

Never dispose of the appliance in your normal domestic
waste. This product is subject to the provisions of European
Directive 2012/19/EU.
Dispose of the appliance through an approved disposal facility or your
municipal waste facility. Please observe the currently applicable regula-
tions. Please contact your waste disposal facility if you are in any doubt.
Do not dispose of the mains adapter in your normal
domestic waste. This mains adapter is subject to the
provisions of European Directive 2012/19/EU WEEE
(Waste Electrical and Electronic Equipment).
Dispose of the mains adapter at an approved disposal centre or your
community waste facility. Please observe the currently applicable regula-
tions. Please contact your waste disposal facility if you are in any doubt.
NOTE
► The integrated rechargeable battery in this appliance cannot be
removed for disposal.
To prevent risks, the removal or replacement of the battery may only
be carried out by the manufacturer or the manufacturer's customer
service department or a similarly qualified person.
When disposing of the appliance, indicate that the appliance
contains batteries.
► Dispose of the oil and oil container in accordance with local rules
and regulations.
│ GB │ IE
■ 32
Cause
The battery is empty.
The appliance is
defective.
The battery is empty.
The hairs may be too
long.
It is possible that the
hairs are too short.
You are working too
fast.
Solution
Charge the battery.
Contact the Customer Service
department.
Charge the battery.
Shorten the hairs to about 0.3 - 0.5 cm.
See also the section "Tips and Tricks".
The hairs should have a length
of 0.3 - 0.5 cm.
Move the appliance more slowly over
your skin.
SBT 3.6 D2