Mount The Wall Controller; Mounting Plate - Bigassfans Powerfoil X2.0 Manuel D'installation

Mount the wall controller

CAUTION: The wall controller and upper temperature sensor contain sensitive electronic PCBs. Use
extreme care when handling! ESD precautions recommended.
The SmartSense wall control incorporates an internal temperature sensor and should be mounted within the same
zone as the upper temperature sensor. The wall controller can be mounted to a standard 2 in. x 4 in. (5.08 cm x
10.16 cm) electrical switch box or surface-mounted on a wall or column. It does not have to be located adjacent to
the fan controller; each controller is independently wired to the fan. Note: A junction box is not supplied with the
wall controller.
To install the wall controller:
1. Route power wiring to the mounting location.
2. Attach the mounting plate to the junction box in the wall with the two (2) provided 6-32 x 7/8" Phillips screws.
3. Route the wall controller power cord through the opening in the center of the mounting plate. Guide the
power cord down the bottom of the mounting plate in the slot provided.
4. Rest the wall controller in the wall controller cover, and then secure the controller cover to the mounting plate
with the four (4) provided 6-32 x 3/8" Phillips screws as shown below.
Mounting Hardware:
a. (2) 6-32 x 1-1/4" Phillips Screw
b. (4) 6-32 x 3/8" Phillips Screw
Controller
6
b
SmartSense
Wall Controller
Cover
WWW.BIGASSSOLUTIONS.COM
a

Mounting Plate

(fits standard junction box)
© 2015 DELTA T CORP. ALL RIGHTS RESERVED.
Junction Box
(in Wall)