Makita 5008MG Manuel D'instructions page 5

ENGLISH
1. Depth guide
2. Lever
3. Positive stopper
4. Arrow on positive stopper
5. Base
6. Switch trigger
7. Lamp
8. Hex wrench
SPECIFICATIONS
Blade diameter
Max. Cutting depth
No load speed (min
Overall length
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. DOUBLE INSULATION
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects to
the operation of other equipment. With a mains
impedance equal or less than 0.37 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
Explanation of general view
9. Protrusion
10. Shaft lock
11. Saw blade
12. Hex bolt
13. Outer flange
14. Inner flange
15. Ring
16. Vacuum cleaner
Model
at 90°
at 45°
at 50°
-1
)
Net weight
Safety class
SPECIFIC SAFETY RULES
END201-3
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to
circular saw safety rules. If you use this tool unsafely
or incorrectly, you can suffer serious personal injury.
Danger:
1. Keep hands away from cutting area and the blade.
Keep your second hand on auxiliary handle, or
motor housing. If both hands are holding the saw,
ENE028-1
they cannot be cut by the blade.
2. Do not reach underneath the workpiece. The guard
cannot protect you from the blade below the
workpiece. Do not attempt to remove cut material
when blade is moving.
ENF002-1
CAUTION: Blades coast after turn off. Wait until blade
stops before grasping cut material.
3. Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth
should be visible below the workpiece.
4. Never hold piece being cut in your hands or
across your leg. Secure the workpiece to stable
platform. It is important to support the work properly
ENF100-1
to minimize body exposure, blade binding, or loss of
control.
A typical illustration of proper hand support,
workpiece support, and supply cord routing (if
applicable). (Fig. 1)
5. Hold power tool by insulated gripping surfaces
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
Contact with a "live" wire will also make exposed metal
parts of the power tool "live" and shock the operator.
17. Rear handle
18. Front grip
19. Rip fence (Guide rule)
20. Adjusting screw
21. Triangular rule
22. Limit mark
23. Brush holder cap
24. Screwdriver
5008MG
210 mm
75.5 mm
57 mm
51.5 mm
5,200
332 mm
4.8 kg
/II
GEB013-1
5