Dyno LabelManager PnP Démarrage Rapide page 6

Become familiar with the features shown in Figure 2.
1
5
4
Power button/Status light
1
2 Cutter button
3 Label exit slot
Inserting the Battery
The label maker is powered using a rechargeable lithium-ion battery.
To insert the battery
Open the side cover of the label maker.
1
Remove the battery compartment cover.
2
See Figure 3.
Insert the battery into the battery
3
compartment as shown.
Replace the battery compartment cover.
4
Close the side cover of the label maker.
5
Remove the battery if the label maker will
NOTE
not be used for a long period of time.
2
2
3
Figure 2
USB port
4
5 Side cover
6 Cleaning tool
7
6
9
Battery compartment
7
8 Label compartment
9 Serial Number label
8
Figure 3