Dyno LabelManager PnP Démarrage Rapide page 12

Troubleshooting
Review the following possible solutions if you encounter a problem while using
your label maker.
Problem/Error Message
Poor Print Quality
Poor Cutter Performance
Printer is disconnected or turned off
Printer error
Battery level is too low to print
Battery is not functioning properly
Battery is not charging
Battery level is getting low or too low
If you still need assistance, visit the support section of the DYMO Web site at
www.dymo.com.
8
Solution
Ensure label cassette is installed properly.
Clean the print head. See Cleaning the Label Maker.
Replace the label cassette.
Clean the cutter blade. See Cleaning the Label Maker.
The label maker is disconnected or turned off. Make sure
the USB cable is connected and the printer is turned on.
Make sure the label cassette is inserted properly and is not
jammed or empty.
Battery charge level is too low to print. Charge the battery
and reprint the label.
Verify the battery is inserted properly. Otherwise, contact
Customer Support.
Make sure the label maker is connected to a powered
USB port.
Connect the label maker to a powered USB port to
begin charging.