Switching On The Heating System - Stiebel Eltron IA Utilisation Et Installation

Press the
3.
▼ button within
the first 2 sec.
of the program-
ming phase
during the 50 %
heating cycle.
N O T E !
If several receivers are connected to the same feed
line, then all are simultaneously ready to program.
The radiant heater begins to briefly light up 'at random'.
Individual channels/transmitters can now be assigned
to the respective receiver.
You can stop the flashing if you briefly push the
STOP button of a transmitter which has already been
programmed.
The channel assignment/change can now be made
without you having to disconnect the individual
receivers.

Switching on the heating system

!
P R E R E Q U I S I T E !
The transmitter is programmed.
Press the ▲ or ▼ button.
Programming additional transmitters /
switching on the heating system
The transmitter is programmed.
- 2 7 -
Heating switches
off.