Programming The Radio Transmitter - Stiebel Eltron IA Utilisation Et Installation

Programming the radio transmitter

Programming the transmitter
!
C A U T I O N !
Do not connect L to L
→ different potentials
Hints for transmitter assignment:
• Before commencing with the programming of the first transmitter,
it is recommended to wait a few ON/OFF cycles in order to adjust
yourself to the cycle.
• Do not press any transmitter buttons without reason as long as the
receiver is still in programming mode.
• If receivers are unnecessarily in programming mode, then this can
be aborted by pressing the STOP button on a programmed hand-
held transmitter.
PE (green/yellow)
STAS3
1 = N (blue)
2 = L
3 = L (bridged with 2)
Feed cable
Consumer
PE (green/yellow)
STAK3
1 = N (blue)
I
2 = L (black)
3 = free (brown)
- 2 4 -
I .