Zanussi ZFU428MW Notice D'utilisation page 22

Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and
the wall unit must be at least 100 mm . Ideally,
however, the appliance should not be posi-
tioned below overhanging wall units. Accurate
levelling is ensured by one or more adjustable
feet at the base of the cabinet.
Warning! It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore be easily
accessible after installation.
A
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate corre-
spond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
22
B
This appliance complies with the E.E.C. Direc-
tives.
Rear spacers
You can find the two spacers in the bag with
documentation.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
4
Levelling
Accurate levelling prevents the vibration and
noise of the appliance during operation. To ad-
just the height of the appliance loosen or tight-
en the two adjustable front feet.
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
2
1
3
www.zanussi.com