Publicité
Les langues disponibles
Les langues disponibles
B. MAKE ESPRESSO COFFEE
1. Open the lid, take out water tank, and pour appropriate water into tank. Do
not exceed the MAX capacity;
2. Put back the water tank and close the lid;
3. Connect power plug, press power button, then machine will automatically
pump water about 2s, and coffee indicator and steam indicator always light
on, then coffee indicator is flashing and the machine start preheating, coffee
indicator will light on and then preheating finished after 2min;
4. Take out filter holder, pour appropriate coffee powder into the filter with coffee
spoon, then press the coffee powder tightly;
5. Lock the filter holder into the group head
6. Put cup(s) under coffee outlet；
7. Start brewing by pressing coffee button；
8. Remove filter holder, knock it out and clean it with hot water immediately, and
lock it again for next use.
Note: Check frequently the water level in the tank. Refill if necessary.
Do not use hands to touch the hot surfaces of machine, especially
brewing outlet, steam nozzle when use machine.
C. FROTHING MILK/ MAKE CAPPUCCINO
1. Prepare espresso first with a large enough cup according to part "B. MAKE
ESPRESSO COFFE.
2. Use whole, fresh cold milk out of the fridge(8℃-10℃), and pour 1/3 milk in
cup.
Note: Use a stainless steel cup, and cup diameter should not less than
70 ± 5mm, due to the volume of milk will increase after frothing.
3. Press steam button, it starts preheating, and steam indicator is flashing, then
wait for lamp lights on；
4. Put a stainless steel cup under steam nozzle；
5. Open knob, release steam, make the steam nozzle floating on the surface of
milk, and adjust the height of steel cup to froth milk;
6. Remove product when finished, turn off the knob, and Pour the frothed milk
into the espresso prepared; now the cappuccino is ready.
TROULBE SHOOTING
Problem
Cause/Result
Water tank is empty
The input voltage or
No water
frequency is inconsistent
comes out
with nameplate
machine malfunctions
steam nozzle clogged
No steam is
Water tank is empty
generated
Machine malfunctions
Too much coffee in filter
Coffee runs
out around
There is coffee in the seal
the edge of
under group head
the filter
Implementation of the
holder
above operation
problems still exist
Coffee
coffee grind is too fine,
comes out
and clogged filter
too slow or
Filter holes are blocked
no coffee
Water tank is not inserted
comes out
There is
Drip tray is filled up
water
leakage on
the bottom of
Machine malfunctions
coffee
machine
The power outlet is not
Machine is
plugged well.
not working
NTC is short circuit
Machine malfunctions
Steam indicator is
The steam
flashing
cannot froth.
The container is too big
Solution
Pour water in water tank
Make sure the voltage and frequency is
consistent with the nameplate
please contact with the authorized service
Clean steam nozzle
Pour water in water tank
please contact with the authorized service
clean the filter, then pour appropriate coffee
powder
Clean the seal under group head
please contact with the authorized service
With thicker coffee powder
Brush / clean the filter
Insert the water tank in place
Please clean the drip tray
please contact with the authorized service
Plug the power cord into a wall outlet
correctly,
please contact with the authorized service
Wait steam indicator lights on.
Use high and narrow cup or garland cup
Publicité
