Programming The Language; Maintenance; Refilling Water; Emptying The Tray - NESTLE NESPRESSO N400 Mode D'emploi

14.9 Programming the language

Use the ON/OFF key to switch on the machine.
MACHINE HEATING
RINSE – PRESS DRAW-OFF KEY
Place a cup under the coffee outlet and press one of the draw-off
buttons (ESPRESSO or LUNGO).
RINSING
READY
Press the programming button until the machine switches over to
programming mode.
FILTER
Press the arrow keys a number of times until the following
message appears:
LANGUAGE
Press the programming button to activate the programming step.
ENGLISH
Use the arrow keys to adjust the language, confirm your settings
by pressing the programming button.
LANGUAGE
Press the arrow keys a number of times until the following
message appears:
EXIT
Press the programming button to quit the programming mode.
READY
72

15. Maintenance

15.1 Refilling water

WATER / FILL
If this information is displayed, drawing off products is no
longer possible. Refill water as described in Chapter 3.3.
READY

15.2 Emptying the tray

TRAY / EMPTY
If this message appears on the display, you can no longer draw
off espresso. You must empty the capsule container first.
Carefully take out the drip tray and the capsule container, it is
filled with water.
NO / TRAY
Empty the drip tray and the capsule container and install it in the
machine again.
READY
The yellow water level indicator appears when the drip tray
is full.

15.3 Machine is scaled

During operation, the machine will get clogged because of
limescale build-up. The degree of scaling depends on the
hardness of the water in your region. The machine will in-
form you when descaling is required. You can still draw off
coffee or hot water/steam. However, we recommend that you
should descale the machine (Chapter 16) within the next few
days.
SCALED / READY