Preparing Steam; Returning To Coffee Ready - NESTLE NESPRESSO N400 Mode D'emploi

9. Preparing steam

Steam can be used for heating liquids and frothing milk for
cappuccino. Make sure that the steam / frothing nozzle (12)
is pushed upwards when liquids are heated. Push down the
frothing aid to froth liquids.
If you do not draw off steam within 1 minute, steam draw-
off mode is deactivated.
During operation, the hot water / steam nozzle may heat up.
However, there is no danger of burns.
Install the steam / frothing nozzle (Fig.7) to obtain a perfect
result.
During frothing some water will escape the system before the
actual steam draw-off. This does not affect the result, e.g.
when frothing milk.
At the start of the water draw-off there can be splashing.The
steam nozzle becomes hot. Avoid direct contact with the
skin!
Use the ON/OFF key to switch on the machine.
MACHINE HEATING
RINSE – PRESS DRAW-OFF KEY
Place a cup under the coffee outlet and press one of the draw-off
buttons (ESPRESSO or LUNGO).
RINSING
READY
Press the steam draw-off button.
MACHINE HEATING
STEAM / READY
66
Immerse the frothing aid in the milk to be frothed or liquid to be
heated.
Turn the hot water / steam valve to Hot Water / Steam (Fig. 4).
STEAM / PORTION
Your product is being prepared.
VALVE / CLOSE
Turn back the hot water / steam valve to Coffee (Fig. 3).
STEAM / READY
You can stop the steam draw-off operation by turning the hot
water / steam valve to Coffee (Fig.3).

10. Returning to Coffee Ready

Deactivate steam draw-off mode by pressing the steam draw-off
button again.
VALVE / OPEN
Place a cup under the steam/hot frothing nozzle.
Turn the hot water / steam valve to Hot Water / Steam (Fig. 4).
MACHINE COOLING
VALVE / CLOSE
Turn back the hot water / steam valve to Coffee (Fig. 3).
READY