Programming - Hoppe AutoLock Notice De Montage Et D'utilisation

8. Programming the eHandle AutoLock for windows
The eHandle AutoLock for windows must first be programmed.
Step 1:
Execute the programming procedure for the eHandle AutoLock for
windows via an EnOcean-enabled smart home central control unit
(please note the technical data set out in Section 12). The specific
product codes for the eHandle AutoLock for windows must be stored
in the smart home central control unit. The respective product codes
can be found on the sticker provided or on the locking unit.
• Enter the EnOcean ID and the initial security code into your smart
home central control unit or
• scan the QR code on the label, e.g. using a smartphone and the
corresponding app.
Step 2:
Press the release button on the eHandle AutoLock for windows and
hold it throughout the entire programming procedure until the following
steps are complete:
• The LED flashes red five times (do not let go of the release button).
• The LED flashes green five times.
• Let go of the release button.
The eHandle AutoLock for windows is now connected to your smart
home central control unit.
You can find step-by-step instructions for the smart home central con-
trol units that we are familiar with in the "Service" section of our website
at http://www.hoppe.com.
EnOcean ID
Initial security code
QR code
27