Freqently Asked Questions - Marmitek X-10 SM10 Guide Utilisateur

You can test the SM10 using the test button to activate the module(s) and the All Units Off
button to switch off the module(s).
alarM Panel SM10 x-10 MOdule

FreQenTlY aSKed QUeSTiOnS

What is the reason for modules to switch on/off spontaneously?
It is possible that a Marmitek X-10 System is installed at one of your neighbours using the same
House Code. To solve this problem try to change the House Code of your system, or have FD10
Phase Coupler/Filter installed at your incoming mains.
My modules will not respond to my controller.
Make sure that the House Code on all Modules and Controllers are set to the same House
Code (A .. P).
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one TM13 Transceiver or Marmitek
X-10 Security Console installed in your house. These components will translate the radio signals
to the Marmitek X-10 signal on the power line. Using several remotes and sensors, you only
need one central transceiver.
am i able to increase the range of my remotes by using more Transceivers?
Yes, you can use more than one TM13 Transceiver in your home when the range of your
remotes is not sufficient. The TM13 is using so called collision detection to prevent signals to
be disturbed when more than one TM13 is transmitting. TM13's will wait for a quite power line
before transmitting their data. To prevent your Marmitek X-10 System to become slow or to
prevent dimming from becoming less smooth, make sure that the TM13 units are placed as far
away from each other as possible.
SM10™ 7