EUFAB 13495 Manuel De L'opérateur page 7

6.2 INSERTING THE BATTERIES
Figure 2: Opening the
battery compartment
6.3 FUNCTIONS
Pressing the switch (Position 1 in the overview) multiple times allows you to switch the light field (Position 2 in the
overview) and the torch (Position 3 in the overview) on and off in the following sequence:
Torch on – Torch off – Light field on – Light field off
6.4 ATTACHMENT
In order to be able to use the torch and still have your hands free, you may
1. hang it by the rotating fixture hook (Position 9 in the overview), e. g. to a tent pole, or
2. secure using the fixture magnet (Position 5 in the overview) to a smooth, magnetic surface. Pay attention to ensure
that the surface, for example, the paint job of the car, is not damaged.
7. MAINTENANCE AND CARE
7.1 MAINTENANCE
The torch is maintenance-free when used in accordance with the intended purpose.
7.2 CARE
Clean the torch with a dry, soft cloth only. Do not use any aggressive cleaning agents or solvent-based cleaners.
Never allow liquids to ingress into the torch. In the event of a long-period of non-use, remove the batteries from the
compartment.
8. NOTES REGARDING ENVIRONMENTAL PROTECTION
Do not dispose of electrical devices with the household waste! Electrical and electronic scrap must be
collected separately and disposed of in an environmentally responsible manner for recycling. Please contact your
community or city administration regarding disposal options for electrical and electronic scrap.
At the end of their lifetime, used batteries and battery packs are not to be disposed of in the household
waste - or negligently in the environment. Hand in used device batteries/battery packs to the collection points
at the store (dealer). This makes a considerable contribution towards protecting our environment. Some
communities may also collect used batteries/battery packs via mobile stations or recycling centres.
9. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
Germany
Fold the fixture hook (Position 6 in the overview) backwards, (Position 9 in the overview).
Open the battery compartment using a small screwdriver inserted behind the catch of
the lid Figure 2 to gently push the catch in the direction of the fixture magnet (Position 5
in the overview). Once the catch has been released you can lift the battery compartment
lid at this side and then remove (Position 8 in the overview). Insert the batteries into the
compartment (Position 7 in the overview). Make sure you pay attention to the correct po-
ling, the position is marked on the base of the battery compartment. Replace the battery
compartment lid and push down until the catch locks into position.
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
7