Publicité
Les langues disponibles
Les langues disponibles
6. Operation
6.1
1.
2.
3.
6.2
Audio Tone Discrimination
The device beeps quietly when it detects a small metal object; it
will beep loudly when a larger metal object is detected.
Sensitivity
Insert the tip of a small screwdriver into the SENS ADJ. hole. To
set the ideal sensitivity rate, slowly rotate clockwise to increase
or anti-clockwise to decrease the sensitivity, until both the audio
and visual alarms signal continuously. Then slightly turn anti-
clockwise.
Reset
Press the reset knob to reset the device.
Low-Battery Indication/Earphones
Replace the battery if the device beeps continuously and the
LEDs do not burn.
Using earphones will help you hearing the audible alarm in noisy
environments. Also, the batteries will last longer.
7. Care and Maintenance
•
•
V. 02 – 26/05/2020
CS10MD2
Basic Operation
Hold the device by the handle and switch it on. Wait for the
device to finish the initialisation. The device is ready-for-
use when the green LED burns.
Sweep the device over the body: it will beep and the alert
LED will burn when a metal object is found.
Switch off after use.
Functions
The device does not need any particular maintenance.
However, it is advisable to clean it occasionally to keep it
looking like new. Do not use harsh chemicals, cleaning
solvents or strong detergents.
Remove the battery if the device will not be used for a long
time.
5
©Velleman nv
Publicité
