Electric Connection; Disposing Of The Packaging; Disposing Of Your Old Refrigerator; Placing And Installation - Beko FNE 1000 Manuel D'utilisation

Electric connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
The connection must be in
compliance with national
regulations.
The power cable plug must be easily
accessible after installation.
The specified voltage must be equal
to your mains voltage.
Extension cables and multiway
plugs must not be used for
connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated before
it is repaired! There is danger of
electric shock!

Disposing of the packaging

The packing materials may be
packing materials out of the reach
of children or dispose of them by
classifying them in accordance with
the waste instructions. Do not dispose
of them along with the normal
household waste.
The packing of your refrigerator is
produced from recyclable materials.
Disposing of your old
refrigerator
Dispose of your old refrigerator
without giving any harm to the
environment.
You may consult your authorised
dealer or waste collection center of
your municipality about the disposal
of your refrigerator.
cut out the electric plug and, if there
are any locks on the door, make
them inoperable in order to protect
children against any danger.

Placing and Installation

A
If the entrance door of the room
where the refrigerator will be
installed is not wide enough for the
refrigerator to pass through, then
call the authorised service to have
them remove the doors of your
refrigerator and pass it sideways
through the door.
1. Install your refrigerator to a place
that allows ease of use.
2.
heat sources, humid places and
direct sunlight.
3. There must be appropriate air
ventilation around your refrigerator
in order to achieve an efficient
operation. If the refrigerator is to
be placed in a recess in the wall,
there must be at least 5 cm distance
with the ceiling and at least 5 cm
with the wall. If the floor is covered
with a carpet, your product must be
elevated 2.5 cm from the floor.
4. Place your refrigerator on an even
floor surface to prevent jolts.
9
EN