Use; Switching The Night Light Function On And Off; Mounting The Radio Wall Clock; Switching Between Summer And Winter Time - ADE CK 1710 Mode D'emploi

‚ You can also wait until the wall clock automatically switches to receiving mode at a
later point in time. The reception is usually better at night.
‚ If radio signal reception is not possible at all, you can also set the time by hand
(see "Set the time manually").

Use

Switching the night light function on and off

There is a sensor to measure brightness in the digit "6" of the clock face.
− Set the ON/OFF switch on the clock back to ON, if the clock face should be
automatically illuminated as it gets darker.
− Set the ON/OFF switch to OFF, if the clock face should not be illuminated.
To test the clock light function, you can press the button .

Mounting the radio wall clock

Located at the back of the clock is the hanging eyelet.
− Hang the clock up on a nail or a screw.
Maintain a secure attachment so that the clock does not fall off and become
damaged.

Switching between summer and winter time

Switching between summer and winter time, or vice versa, takes place automatically
with good time signal reception.

Restart radio transmission

1. Press and hold the REC button for a few seconds.
2. Release the button when the clock hands begin to turn. The radio wall clock then
indicates "12 o'clock".
The clock then attempts to receive a radio signal within the next minutes.
‚ If the clock receives a sufficiently strong radio signal, the hands set themselves to
the correct time.
‚ If the clock does not receive a sufficiently strong radio signal, it resets itself to the
previously indicated time.
Radio Wall Clock CK 1710
Use
17