Zanussi ZFC31401WA Notice D'utilisation page 21

Problem
The appliance is noisy.
Audible or visual alarm is on.
Power indicator light is flashing.
The lid doesn't close completely.
The lid is difficult to open.
The lamp does not work.
The compressor operates contin-
ually.
There is too much frost and ice.
The temperature in the appliance
is too low/too high.
www.zanussi.com
Possible cause
The appliance is not supported
properly.
The cabinet has been recently
switched on or the temperature
in the appliance is too high.
An error has occurred in measur-
ing the temperature or the appli-
ance is not working properly.
Food packages are blocking the
lid.
There is excessive frost.
The lid gaskets are dirty or sticky. Clean the lid gaskets.
The valve is blocked.
The lamp is defective.
Temperature is set incorrectly.
Large quantities of food to be
frozen were put in at the same
time.
The room temperature is too
high.
Food placed in the appliance
was too warm.
The lid is not closed properly.
The lid is not closed correctly or
the gasket is deformed/dirty.
The water drainage plug is not
correctly positioned.
Temperature is set incorrectly.
The temperature regulator is not
set correctly.
The door is not closed correctly.
Solution
Check if the appliance stands
stable.
Refer to "High Temperature
Alarm" and if the problem still oc-
curs contact the nearest Author-
ized Service Centre.
Contact the nearest Authorized
Service Centre.
Arrange the packages in the right
way, see the sticker in the appli-
ance.
Eliminate excess frost.
Check the valve.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food to cool to room tem-
perature before storing.
Check if the lid closes well and
the gaskets are undamaged and
clean.
Refer to "Closing the door".
Position the water drainage plug
in the correct way.
Refer to "Operation" chapter.
Set a higher/lower temperature.
Refer to "Closing the door".
21