Assembly - Haussmann S1M-KM8-115-1 Guide D'utilisation

ASSEMBLY

WARNING! Ensure the tool is unplugged from the power source before
making adjustments or when installing and removing accessories.
Wheel guard
Place the wheel guard (8) on the spindle collar (5). Adjust the position of the wheel
guard (8) to the requirements of the work process. Close the latch to secure the
guard.
The closed side of the wheel guard (8) must always point towards the
operator.
Auxiliary Handle
(see figure B)
When working with the grinder, always mount the auxiliary handle.
This tool has two holes to change the auxiliary handle position, please select the
proper one from "1" to "2"
Mounting the grinding/cutting accessories
Before performing any modifications on the tool itself, turn tool off and unplug from power source.
WARNING! Use only grinding wheels, discs and accessories that are rated
for speeds that are at least as fast as the maximum speed of the tool.
Grinding wheels, discs and accessories may become hot during use.
Do not touch them until they have cooled.
Grinding Wheels/Cutting Discs
Clean the grinder spindle and all parts to be mounted. Place the mounting flange
onto the spindle. Place the grinding wheel or cutting disc onto the mounting flange.
The arbor (mounting hole) in the grinding wheel or cutting disc must fit properly
onto the mounting flange without looseness. Thread the clamp nut onto the
spindle. Engage the spindle lock, then tighten the clamp nut using the spanner. Do
not overtighten the clamp nut.
ATTENTION: After mounting the grinding, wheel/disc or accessory, check to
make sure that it is mounted correctly and turns freely prior to turning the tool on.
Flap disc
Depending on the application and if necessary, remove the wheel guard (8).
Place the special retainer mounting flange (9) and the flap disc on the grinder
spindle (6). Screw on the clamping nut (11) and tighten it with the two-pin spanner.
Cup brush
Depending on the application and if necessary, remove the wheel guard (8)
The grinding tool must be screwed onto the grinder spindle (6) until it rests firmly
against the grinder spindle flange at the end of the grinder spindle threads. Tighten
with an open-ended spanner.
9
!
!
!