Height Adjustment Of The Feet; Cleaning | Maintenance; Technical Data - Drive DINO Mode D'emploi

Height adjustment of the feet

1
Ensure that all four legs are adjusted to the same height.

Technical data

Produkt
Article number
Max. load
Diameter of seat surface
Overall height
Overall width
Total height of seat surface
Height adjustment (8 steps)
Total weight
Leg material
Clip closure material
Seat material
Drive Medical GmbH & Co. KG | As per: 18.06.2020 | Errors and alterations excepted
Before using the product,
adjust it to the desired
height (pic. 1). To adjust the
height of the legs:
Press button (1) and at the
same time, pull the leg out
or push it in until the but-
ton clicks into place in the
desired position (2). En-
sure that the pushbutton
has correctly clicked into
place.

Cleaning | Maintenance

• Clean regularly with a moist cloth!
• Do not use any aggressive cleaning agents!
• Do not use abrasive cleaners!
• Do not use any high-dose chlorine and vinegar-based
cleaners!
• To disinfect, a spray disinfectant can be used such as
Descosept AF or Bacillol AF.
• Check the screws regularly and tighten, if necessary.
• In the event of defects, contact your specialist dealer
from whom you purchased this product.
550500100
130 kg
32 cm
52 cm
45 cm
2,7 cm
34 - 52 cm
1,6 kg
Aluminium anodised
Brass
PP (polypropylene)
EN
9
Instructions for use DINO