Teka LI4 1270 E Manuel D'instructions page 19

11 Appliance does not spin
12 Emptying water from drum
13 Laundry not properly spun
14 Traces of detergent
laundry
15 Washing results unsatis-
factory
ERROR DISPLAY
In case of a malfunction, the appliance will identify the problem by showing an error code on the display.
Error code
For all the other error codes displayed, cut off the electricity supply, turn off the water tap and contact your nearest
Service Centre.
Anti-imbalance safety device tripped because laundry not evenly distrib-
uted in drum. If laundry is still wet at end of cycle, rearrange it in the drum
by hand and repeat spin programme only.
In the event of a power blackout or appliance failure, the water can be
removed from the drum using the emergency procedure.
Large items screwed up and not evenly distributed within drum. Always
wash a mix of large and small items.
on Many phosphate-free detergents contain substances with low water solu-
bility.
Select Rinse programme or brush the laundry.
Probably too little detergent or unsuitable detergent used
-
Difficult stains not dealt with before washing
-
Correct temperature not set
-
Basket overloaded.
-
Door not properly closed. Try reclosing.
Aqua stop device tripped. Cut off power supply, turn off water tap and contact nearest
service centre.
Water not taken in for washing. See point 2 in troubleshooting table.
Water not pumped out. See point 4 in troubleshooting table.
Key to problem
EN
18