Troubleshooting - Teka LI4 1270 E Manuel D'instructions

6. TROUBLESHOOTING

This produce complies with the relevant regulations governing the safety of electrical equipment. For safety rea-
sons, any technical inspections or repairs must be performed by qualified staff, to prevent all hazards for the user.
If the appliance does not work, before calling the After-Sales Service, to avoid unnecessary expense, check your-
self that the operations listed in this troubleshooting table have been carried out.
1 Appliance does not start
2 No water filling
3 No water visible in washing
drum
4 Water not pumped out
5 Water not pumped out after
last rinse in delicate fabrics
and wool
grammes
6 Water takes in and pumps
out water continually
7 Strong vibrations
spins
8 Too much foam formed in
tank and flowing out of
drawer
9 Water on floor
10 Not all fabric conditioner
used or too much water left
in compartment
Check that:
- plug is properly connected to socket
- door is securely closed
- "Start/Pause" button has been pressed.
Check that:
plug is properly connected to socket
-
door is securely closed
-
water tap is turned on
-
water intake hose filters not fouled.
-
water intake hose not trapped or kinked.
-
No malfunction.
The water level is below the level of the glass in the door because new
appliances use very little water to achieve the same washing and rinsing
results.
Check that:
drain hose is not kinked
-
drain pump not fouled.
-
It is not a malfunction: pause programmed into washing programme to
prevent creasing of fabrics.
wash pro-
To pump out water, proceed as described in "Programme End" point.
Check that end of drain hose is not too low down.
during Check that:
Appliance is properly levelled
-
washing machine not too close to walls or kitchen units
-
internal unit on flexible mounts locked in position.
-
Check that:
detergent used is recommended for automatic washing machines
-
and not for hand washing
quantity used is as stated in manual and no more
-
Check that:
water intake hose fittings not loose
-
end of drain hose still correctly positioned.
-
Check that detergent drawer siphons are correctly fitted and not fouled.
EN
.
17