HERKULES BKS 315/230 Mode D'emploi D'origine page 15

Anleitung_BKS_315_230_SPK7__ 07.08.14 14:27 Seite 15
Contact with the saw blade in the uncovered
saw zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of work-
pieces.
Saw blade fracturing.
Catapulting of faulty carbide tips from the saw
blade.
Damage to hearing if ear-muffs are not used as
necessary.
Harmful emissions of wood dust when used in
closed rooms.
5. Technical data
AC motor
Power P
Power P
Idle speed n
0
Cutting-off wheel
Number of teeth
Table size
Cutting height max.
Height adjustment
Tilting saw blade
Extractor socket
Noise emission values
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighbouring
operations. Reliable workplace values may also vary
230 V 50Hz
S1 1200 W
S6 20% 2000 W
2800 min -1
Ø 315 x Ø 30 x 3,6 mm
24
800 x 550 mm
83 mm / 0°
60 mm / 45°
infinite 0 -83 mm
infinite 0° - 45°
Ø 100 mm
93 dB(A)
3 dB
104 dB(A)
3 dB
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
Switch the appliance off when it is not in use.
n
6. Before putting the machine into
operation
Unpack the bench-type circular saw and check it
for damage which may have occurred in transit.
The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted
to a strong base. The machine must stand
securely, i.e. the saw must be securely bolted to
the floor.
All covers and safety devices have to be
properly fitted before the machine is switched
on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machineʼs moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
7. Assembly
Important! Pull out the power plug before
carrying out any maintenance, resetting or
assembly work on the cutting-off machine!
7.1. Setting up the saw (Fig. 1-6)
Place the saw table on a flat surface.
Screw the feet (18) and the saw table (1) loosely
together.
Important: It is imperative that the foot with the
opening (19) for the switch/plug block is
mounted correctly on the left front side (see Fig.
GB
15